Filter
Top Products
PDS-Series
Page 6 Installation Instructions
Optional Installations
AST-2446 Installation/ Custom Length Pipe
(1-1/2” NPT)
NOTE: These installation instructions apply only to installing the
PDS Base Box. For complete AST-2446 Custom Length Pipe
(1½” NPT) installation instructions, please refer to the
AST-2446 Custom Length Pipe (1½” NPT) Installation
Instructions.
1. After the upper pipe has been properly secured to the ceiling
structure, screw the base box to the lower portion of the
AST-2446 and secure it with the M6 x 8mm set screw (Figure 6).
2. Make the necessary viewing adjustments (please see Page 5,
Adjusting the Projector).
3. To install the escutcheon ring, open the ring, place it around the
AST-2446 extension pipe, and close. The escutcheon ring must
then be fitted into place.
4. When all final adjustments have been made, tighten all hardware.
PP-FCTA Installation
NOTE: These installation instructions apply only to
installing the PDS Base Box. For complete
PP-FCTA installation instructions, please refer to
the PP-FCTA Installation Instructions.
1. Secure the 1½" (NPT) nipple to the ceiling plate and
secure the nipple or (custom length of 1½” NPT pipe)
by using one (1) M5 x 16 Phillips head screw
(supplied) to the stud plate (Figure 7).
2. Thread the base box to the pipe, or nipple, and secure
with the M6 x 8mm set screw.
3. To install the escutcheon ring, open the ring, place it
around the pipe, and close. The escutcheon ring must
then be fitted into place.
4. When all final adjustments have been made, tighten all
hardware.
CAUTION
: The set screw must be used to stabilize
the 1½" (NPT) nipple or optional pipe.
Figure 6
Figure 7
Projector
Bracket
Set Screw (tighten once
the desired position is
locked in).
1-1/2” (NPT) Nipple,
or Pipe
Ceiling
Frame
PP-FCTA
Escutcheon Ring
Ceiling
Tile
XL6000CM
PDS Base
Box
Projector
Bracket
AST-2446, or Custom Length
of Pipe
Projector
Set Screw (tighten once the
desired position is locked in).
Custom Length
of NPT Pipe