Filter
Top Products
Supplies and Driver Settings 11
7. Place the leading edge of label stock under the
"label stock" symbols on the Throat Guides.
The label stock should be placed far enough into the throat
of the printer to correctly position the Movable Throat
Guide but not yet into the printer itself. The label stock
should be biased against the Fixed Throat Guide.
8. Slide the Movable Throat Guide inward until it almost
touches the label stock. There must be slightly more space
between the Throat Guides than the width of the label
stock. If the label stock is pinched by the guides, poor print
quality or even feeding problems could result.
9. Feed the label stock further into the printer until it senses
the label and automatically feeds it through the printer.
If the printer fails to feed the label stock, press the Feed
button on the front panel while continuing to guide the
label stock into the printer. The printer can sense through-
hole stock as well. If you are using label stock that has a
hole punch to identify a transition from backing to label,
you can adjust the Sensor Position Adjust tab to position it
5. Place label stock
on Roll Arm.
6 Slide Roll Guide
assembly inward.
7. Place the leading edge of the
label stock just past the Throat
Guides, but not into the printer
itself.
8. Slide Throat
Guide inward
until it almost
touches the
label stock.
Label Stock
9. Feed the label stock further
into the printer until it senses
the label and automatically
feeds it through the printer.
510943.qxd 12/5/2005 1:02 PM Page 11
TOC
INDEX