Filter
Top Products
DT Chassis Printers/Plotters
Introduction
1-1
Windows and Windows NT are trademarks and Microsoft is a registered trademark of
Microsoft Corporation.
Ethernet is a registered trademark of Xerox Corporation.
All other brand and product names are trademarks, service marks, registered trademarks or
registered service marks of their respective companies.
Copyright Information
The Firmware (Software) resident in the Printer is owned by Printrex or its suppliers and is
licensed for used only on a single printer in the user’s Trade or Business. The User agrees
not to, and not to authorize or permit any other person or party to duplicate or copy the
Firmware or the information contained in the nonvolatile or programmable memory. The
firmware (Software) is protected by applicable copyright laws and Printrex retains all rights
not expressly granted. In no event will Printrex or its suppliers be liable for any damages or
loss, including direct, incidental, economic, special, or consequential damages arising out
of the use or inability to use the Firmware (Software).
Firmware (Software)
Information
Overview
This User Guide describes the general operation and care of the DT (Desk Top) Chassis
series of industrial printers/plotters. The specific DT Chassis models covered by this guide
are the 840 DL/G, 820 DL/G, 820G and 810.
These products are designed for use in a variety of environments, including rugged mobile
data logging and exploration systems. While highly durable and reliable in service, best
performance and product life will be assured if some degree of care is taken when installing
the printers and when providing routine maintenance.
Reading the following sections describing the setup, operation and basic care of the printer
will very likely answer questions you might have regarding these aspects of using Printrex
products. Should you have further questions, more information is available as described in
the Additional Documentation section of this guide. If the documentation fails to address
your concerns, please contact Printrex support (see Contact Information) and we will make
every effort to provide a solution.
Refer to the following table for the discriminating DT Chassis features.
Model 840DL/G 820DL/G 820G 810
Print Speed (ips) 4 2 2 1
Integrated Internal Roll ü ü ü ü
Bottom Feed Fan-fold ü ü - -
Film/Mylar Media Support ü ü ü ü
Win95/98/ME and Win2000/XP Support ü ü ü ü
Vertical Line Adjustment ü ü ü ü
Extended Media Controls ü ü ü -
32 Level Gray Scale Printing ü ü ü -
Autorange 115/220VAC Power ü ü ü ü
Fan Cooled ü - - -
CE Certification (ITE, Safety and EMC) ü ü ü ü
FCC Class A ü ü ü ü