Filter
Top Products
SATAII150 and SATA300 TX Series Quick Start Guide
6
1. Install the disk drives into the drive bays of your system.
2. Attach the power cables to the disk drives.
3. Attach one Serial ATA data cable to each Serial ATA disk drive. Then attach
the other ends of the cables to the connectors on the SATAII150 TX4 card
(below).
Note
If you are using a Promise SuperSwap 1100 or 4100 enclosure in
your PC:
• Connect the power cables to the SuperSwap enclosure.
• Attach a SMBus cable from the Management Connector on
the SATAII150 TX4 card to the Management Connector on
the first enclosure
These actions are described in Chapter 2 of the SuperSwap User
Manual.
TX4
150
ATAII
Port 1 /
Channel 1
Management
Connector
Port 2 /
Channel 2
Port 3 /
Channel 3
Port 4 /
Channel 4
SATAII150 TX4
Serial ATA Controller card
Individual LED
Connectors
Aggregate LED
Connectors