Filter
Top Products
All rights reserved Page 13
Step 5: Close Cable Compartment
Ensure that the Ethernet cable is properly routed and exiting the unit
through the notch at the bottom of the cable compartment.
Position the cable cover so that the notch in the cover ts over the Ethernet
cable (not pictured) and the large tabs on the cover are aligned below the
holes in the unit.
Align the small tabs in the bottom cover with the holes in the unit.
Slide cover upward until all tabs (large and small) on the cover snap into
their respective holes on the enclosure.
1.
2.
3.
4.