Filter
Top Products
Page 8 Copyright © 2006 Proxim Wireless
Step 2: Attach cables
Note:
Depending on your application and location, you may nd it easier to mount
the unit before you attach cables to it. If this is the case, remove the cable
cover (as explained in step 1 below), and then complete Step 3: Mount Unit
to Pole. Return to this step for cabling instructions.
With the laying unit face down, depress both buttons on the back of the
5012-SUR unit, and pull the plastic cover downward to open. Remove
cover.
Connect one end of an Ethernet cable (5.5 mm/.217 in OD maximum; not
supplied) to the unit’s LAN port.
Route the Ethernet cable as shown below.
Connect the other end of the Ethernet cable to the Data and Power Out
port of the DC Injector.
Note:
You must use an 802.3af-compliant power injector, such as the Proxim 1-
Port Power Injector (P/N 4301-xx).
Connect one end of a second Ethernet cable (not supplied) to the Data In
port of the DC Injector and the other end to a switch, hub, patch panel, or
single computer:
Use a straight-through Ethernet cable if you are connecting the unit to
1.
2.
3.
4.
5.
▪