Filter
Top Products
Configure access to the mpx100 management port:
HP0051401-00 A 2
A
d. Enter the CLI command admin start. The default password is config.
e. Enter the set mgmt command at the mpx100 (admin) #> prompt.
f. Select the mode. QLogic recommends static address mode, which is IPv4 Mode 0 [Static] (this is the
default). Enter the IP address, subnet information, and gateway, if applicable. You will lose the
connectivity of the telnet session at this time.
g. If you want to continue using the CLI, restart the telnet session with the IP address you just assigned
to the management port. You now have the management port configured with the appropriate IP
address.
h. Connect the management port cable to your Ethernet network.
******************************************************
* *
* HP StorageWorks mpx100 *
* *
******************************************************
mpx100 #> admin start
Password : config
mpx100 (admin) #> set mgmt
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to the MGMT port.
IPv4 Interface (0=Enable, 1=Disable) [Enabled ]
IPv4 Mode (0=Static, 1=DHCP, 2=Bootp, 3=Rarp) [Static ]
IPv4 Address [10.0.0.1 ] 172.17.136.227
IPv4 Subnet Mask [255.0.0.0 ] 255.255.254.0
IPv4 Gateway [0.0.0.0 ] 172.17.136.1
IPv6 Interface (0=Enable, 1=Disable) [Disabled ]
All attribute values that have been changed will now be saved.