Filter
Top Products
Change the mpx100 mode from iSCSI Connectivity to Data Migration:
HP0051401-00 A 6
A
4. Change the mpx100 mode from iSCSI Connectivity to Data Migration:
Even though the mpx100 is now running data migration capable firmware, it must be set to data
migration mode:
a. At the prompt, type the set system command.
b. Type 1 to change the mode to data migration
c. Enter yes when prompted to reboot.
mpx100 (admin) #> set system
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
WARNING:
If enabled by operator, the Symbolic Name can be embedded as part of the
Only valid iSCSI name characters will be accepted. Valid characters include
alphabetical (a-z, A-Z), numerical (0-9), colon, hyphen, and period.
Changes to the Settings below will be effective after a reboot.
System Symbolic Name (Max = 64 characters) [ ]
Embed Symbolic Name (0=Enable,1=Disable) [Disabled ]
Mode(0=iSCSI Server Connectivity
1=Data Migration
2=Data Migration Demo Mode) [iSCSI Connectivity] 1
Controller Lun AutoMap (0=Enable, 1=Disable) [Enabled ]
System Log Level (Min = 0, Max = 3) [0 ]
WARNING:
The system operation mode has been modified. Changing the
mode of the system will cause all mapping related configuration
of the system to be removed. The system will reboot after
updating the mode.
Do you wish to continue with the operation? [No ] yes