Filter
Top Products
DX Scanner Basic Operation Instructions 7
SEAT MODE
1. Press the Select Switch when the Seat Mode LED is lit. Once selected,
the Scanner will cycle clockwise around the seating commands (Directional
LEDs).
Figure 3. Actuator Selections
2. There are four Seat Positioning
Actuators represented by two
each of the Directional LEDs.
For example, Actuator 1 is
represented by the Forward and
the Forward Right Directional
LEDs. See figure 3. To extend
Actuator 1, wait until the
Forward LED is lit, then press
and hold down the Select Switch. To retract Actuator 1, wait until the
Forward Right LED is lit, then press and hold down the Select Switch.
3. To operate a fifth actuator (if available), use the Environmental Mode
LED (see figure 1). Wait until the Environmental Mode LED is lit, then
press and hold down the Select Switch to extend the actuator. To retract
the actuator, press and hold down the Select Switch again. If you have
any questions regarding the use of the fifth actuator, please contact your
authorized provider.
NOTE: If the Select Switch is not pressed within three scanning cycles
of the Seat Mode, the Scanner will exit that mode.