Filter
Top Products
8 Basic Operation Instructions DX Scanner
ENVIRONMENTAL MODE
1. Press the Select Switch when the Environmental Mode LED is lit. Once
selected, the Scanner will cycle clockwise from the top (forward) LED.
See figure 2.
2. The first four LEDs are momentary selections, and the last four LEDs
are latching selections. Momentary selections will allow the Scanner to
continue its cycle immediately after the switch is released. Latching
selections will not allow the Scanner to continue its cycle until the Select
Switch has been pressed for a period of five seconds. The Scanner will
remain in the selected mode until the Select Switch is pressed for a period
of five seconds.
NOTE: If the Select Switch is not pressed within three scanning cycles
of the Environmental Mode, the Scanner will exit that mode.
SCANNING SPEED ADJUSTMENT
The Scanning Speed is indicated by the amount of time any one LED is lit
before the Scanner moves on to the next LED.
1. Press the Select Switch to power on the Scanner. Wait for the Mode
LEDs to light up.
2. When all three LEDs are lit, press the Select Switch and hold it down.
The Scanning Speed will reset itself to the amount of time you hold
down the Select Switch.
NOTE: The Scanning Speed will need to be adjusted every time the
Scanner is turned on. It cannot be permanently set.