Filter
Top Products
PX502 Tape Library Quick Start Guide
3
By following these instructions, you help ensure that the
system will continue to be safeguarded after it arrives at the
installation site.
Unpack and remove the following components from the
packing materials (see figure 2
):
1 Remove the accessories kit and set it aside.
2 With the help of a second person, lift the library chassis
up and out of the shipping carton.
3 Place the library on a table approximately waist high.
Figure 2 Unpacking the PX502
N
OTE: Unpack the library as close to the installation
location as possible.
W
ARNING: At least two people are required to move the
library chassis.
C
AUTION: Lift the library chassis at the sides. Avoid
putting the weight of the library chassis on
the front bezel.
Accessory kit
Foam
PX502 tape
library
Foam
Front bezel
Lift point
4 Remove the antistatic sheet:
a Cut the tape strips securing the sheet.
b Fold the sheet down.
c With the help of a second person, lift the library up
off of the antistatic sheet.
d Place the library on the table or desk next to the
antistatic sheet.
e If this is a multiple library stack, refer to “Multiple
Library Stacks” on page 15 before proceeding.
The PX502 is ready to install.
Installing the Library 0
Installing a PX502 tape library in a rack consists of the
following steps:
• Locating the Mounting Position
• Installing the Library
• Initial Configuration
Locating the Mounting
Position
0
The PX502 tape library is designed to fit in a standard 19
inch wide rack.
It is important to the library installation to locate the hole
pattern in the rack rails (see figure 3). The library must be
installed at the beginning of the hole pattern. Refer to
table 2
for information on common rack hole types.