Filter
Top Products
Quatech Freedom USB Adapter User’s Manual Installing the software
Step Procedure Description
Step 22 Click the Finish button. The Wizard briefly displays a series of
Unknown hardware found and
Installing messages as it installs each
serial USB port. Your Freedom USB
adapter installation is complete!
Uninstalling from Windows 2000
Follow these steps in the event that you need to uninstall or reinstall
the Freedom USB software.
1. From the Control Panel, select System – Hardware. Select the
Hardware wizard and click Next.
2. Choose Uninstall/Unplug a device. Click Next.
3. Choose Uninstall a device. Click Next.
4. Scroll down to Quatech Freedom USB Serial Adapter; for
example, QSU-100 Quad RS-232 Serial Ports (Group ID2). Select
and click Next.
5. Select Yes, I want to uninstall this device at the Confirmation
screen. Click Next.
Installing under Windows NT
You must install the Windows NT device driver by running the
SETUP program, a command line-based configuration utility for
adding USB bus and ISA bus serial ports.
Note: Windows NT supports up
to 256 serial ports.
Be sure to request an installation CD when you order your Freedom
USB. The CD is free, but it is not shipped automatically. You can also
use an on-line form to request the drivers at
www.Quatech.com/usbnt.htm. You will need to provide your model
and serial number on the form.
Note: NT Installation CDs are
free but need to be specifically
ordered.
See your Quatech sales representative for further information.
Rev 2.02 (2/24/2004) Page 17