Filter
Top Products
3 Hardware Installation
1. Turn off the power of the computer system in which the DSC-100 is to be
installed.
2. Remove the system cover according to the instructions provided by the
computer manufacturer.
3. Make any desired optional jumper setting changes.
4. Install the DSC-100 in any empty PCI expansion slot. The board should be
secured by installing the Option Retaining Bracket (ORB) screw.
5. Replace the system cover according to the instructions provided by the
computer manufacturer.
6. Attach and secure the cable connectors to the desired equipment.
7. Turn on the power of the computer system.
The output of the DSC-100 is a pair of 9-pin D-connectors. All modem control
signals (RTS, DTR, CTS, DSR, DCD, RI) are provided to each port.
J1 - Port 2
J2 - Port 1
DTE/DCE Select
J5
J6
J7
J8
X2
X4
X8
SPAD
Clock multiplier/
scratchpad select
Serial
Port
2
Serial
Port
1
Figure 6 --- Jumper/connector locations
Quatech DSC-100 User's Manual
9