Filter
Top Products
Quatech's "QTPCI" utility supplies the information required when modifying the
serial port settings of the application. This program should be run from real DOS, not in
a Windows DOS box.
Figure 15 shows the Basic Mode display for the DSCLP-200/300 after the "Q"
key has been pressed. In this example, the DSCLP-200/300 uses I/O base address
FFA0 hex and IRQ 3. The hardware revision of the DSCLP-200/300 is also
displayed. Pressing the "N" key will show similar information for all non-Quatech PCI
devices in the system, including those devices integrated on the motherboard.
The QTPCI program is capable only of displaying the PCI configuration. It
cannot be used to make changes.
Figure 15 --- QTPCI.EXE Basic Mode display
DSCLP-200/300 User's Manual 23