Filter
Top Products
7.5 Half-Duplex/Full-Duplex Selection
Using jumper blocks J6 and J8, the transmitters and receivers of each channel
can be enabled and disabled by modem control signals. This allows operation in both
half-duplex or full-duplex modes.
The transmit drivers can be controlled by either the Data Terminal Ready
(DTR) or the Request to Send (RTS) output from the UART. If a jumper is applied
between pins 1 and 4, the drivers are enabled for TxD and AUXOUT when the
UART's DTR signal is asserted. If a jumper is applied between pins 2 and 5, the
drivers are enabled for TxD and AUXOUT when the UART's RTS signal is asserted.
If neither of these jumpers is applied, the drivers remain enabled at all times. When
disabled, the transmit drivers enter a high-impedance state.
The receivers can be controlled by the inverse of the transmit enable. If a
jumper is applied between pins 3 and 6, the receivers for RxD and AUXIN will be
disabled when the transmit drivers are enabled and vice-versa (based on the DTR or
RTS connections on pins 1-4 or 2-5).
To operate in half-duplex DTR mode, apply jumpers between pins 1 and 4 and
pins 3 and 6. To operate in half-duplex RTS mode, apply jumpers between pins 2 and
5 and pins 3 and 6.
To operate in full-duplex mode, leave the jumpers in their factory default
locations, installed in the spare locations of 4-5 and 6-only. The drivers and receivers
are always enabled in full-duplex mode. Figure 23 shows how to select half- or
full-duplex operation.
WARNING:
When operating in half-duplex mode, the transmitter drivers must be
disabled before receiving any data. Failure to do so may result in
multiple active output drivers being connected together, which may
cause damage to the board, the computer, and the external device.
28 DSCLP/SSCLP-200/300 User's Manual