Filter
Top Products
SSP-200/300 PCMCIA serial ports with these applications you might be
forced to remove other serial communications devices from your system
7. To modify the Interrupt Request setting click the resource name and click the
Change Setting button. An Edit Resource window will open up. Inside this
window click on the up/down arrows to the right of the Interrupt Request
value. This scrolls you through all of the allowable resources for your
hardware. Pay attention to the conflict information at the bottom of the
window. Do not select a value that causes a conflict with any other installed
hardware.
8. If any changes have been made to the SSP-200/300’s configuration the card
will automatically be reconfigured to the new resources specified. Any time
a PCMCIA card of this type is inserted Windows 95/98/ME will attempt to
configure the card at these resource settings. Click the Use Automatic
Settings box to reset this card type for automatic configuration.
3.3 Frequently Asked Questions
Basic Configuration List Not Available:
A problem noted on some systems is after a basic configuration has been manually
selected the basic configurations list for the SSP-200/300 is no longer available. The
solution to this problem is to check the “Use Automatic Settings” box and allow
Windows 95/98/ME to reconfigure the SSP-200/300 card. The basic configurations list
should once again be visible.
Base I/O Address Resource Modification Not Allowed:
The SSP-200/300 is configured to allow only a fixed number of base I/O addresses. To
change the I/O address resources for the SSP-200/300 select another “Basic
Configuration.” Refer to the Basic Configurations table for a list of the availabe I/O
address resources for the SSP-200/300
Windows 95/98/Millennium (ME) 3-5