Filter
Top Products
47
Initializing the Scanner
If the scanner’s display locks up or does not work properly after
you connect a power source or install batteries, you might need to
initialize it.
Caution: This procedure clears the scanner’s memory. Initialize the
scanner only after trying all other methods to correct issues.
To initialize the scanner:
1. Turn off the scanner, then turn it on again. “Multi-system Trunking
Scanner” appears.
2. While “Multi-system Trunking Scanner” appears, press 0.
3. Press 1.
4. Press ENT. “Initializing please stand by” appears for about 5
seconds. When the initialization is complete, M000 appears on
the second line of the display. Bank 0 Ch 00 appears.
Do not turn off the scanner until the initialization is complete.
Service and Repair
If your scanner is not performing as it should, take it to your local
RadioShack store for assistance. To locate your nearest RadioShack,
use the store locator feature on RadioShack’s web site (www.
radioshack.com), or call 1-800-The Shack (800-843-7422) and follow
the menu options. Modifying or tampering with the scanner’s internal
components can cause a malfunction and might invalidate its
warranty and void your FCC authorization to operate it.