Filter
Top Products
52
Beyond the Basics
Press TRUNK to start receiving trunked system information.
You can receive the trunked system using the ID Scan Mode.
You can receive those talk groups that you store in a scan list
using ID Search Mode.
You can hear all system talk group activity (except unit-
to-unit calls). This mode lets you fi nd
unknown talk groups.
Your scanner defaults to receive the talk groups in ID search
mode. Press SRCH in the ID search mode and the scanner
will move to the ID scan mode. If you press SRCH again, it
will return to the ID search mode.
ID scan mode
When your scanner fi nds the control channel data, it begins
trunking and id SCAN scrolls on the display until the scanner
fi nds an ID. If you have not programmed any IDs, the scanner
cannot stop on an active conversation.
To remove a scan list from active scanning, press 1-9, 0 (the
number of the scan list). The scan list indicator turns off, and
the IDs in that list are not scanned.
To restore a scan list to active scanning, press its number
again.
One scan list must always be active. If you try and
deactivate all the scan lists, scan list 1 will automatically
be active.
ID scan hold mode
You can press HOLD/RESUME to hold an ID. HOLD and the
ID will appear. To resume scanning, press HOLD/RESUME. To
move the specifi c location, press
e or d or, using 1 through 9,
0 and pressing HOLD/RESUME, you can directly access the
specifi c location you want to which you want to move. The
fi rst number represents the scan list number and the second
number represents the memory location number. To access
the location number 10, use 0.
Note
Note