Filter
Top Products
70
Beyond the Basics
13 1 16 2048 4
14 1 16 4096 8
size code restrictions
If you select size code 12, 13, or 14, there are some
restrictions as to which blocks can be used for these codes.
• Size code 12 can only be assigned to blocks 0, 2, 4, or 6.
• Size code 13 can only be assigned to blocks 0 and 4.
• Size code 14 can only be assigned to block 0.
Since these size codes require multiple blocks, you will be
prompted for the next available block when programming a
fl eet map. For example, if you assign block 0 as size code 12,
you will be prompted for block 2, the next block available,
instead of block 1. And if you assign block 0 as size code
14, you would not see another prompt because all available
blocks have been used.
programming a user fl eet map
1. Select the trunking programming mode and the bank you
want to change.
2. Press e or d to select E1, then press E.
3. Press
e or d to select FLEEt, then press E.
4. Press
e or d to select USr, then press E.
5. Press
e or d to select the size code for the fi rst block, then
press E. The next available block appears on the display.
Then, repeat this step until you have selected a size code
for each block.
programming a Hybrid system
A Hybrid system is simply a Type I system with some blocks
designated as Type II blocks. To program a Hybrid system,