Filter
Top Products
2 SpeedTouch™ Installation
E-SIT-CTC-20030702-0003 v4.0
22
2.2.2 Installation for Mac OS X
Supported Operating
Systems
The following OS must be readily installed on your computer:
• Mac OS X v10.1, v10.2 and v10.3
Note Mac OS X v10.0 users must download the free upgrade to Mac OS X v10.1
to be able to install and use the SpeedTouch™ device.
Minimum system
requirements
For Mac OS X v10.1:
• 121 megabytes (MB) of free disk space (during installation process)
For Mac OS X v10.2 and v10.3:
• 21.6 megabytes (MB) of free disk space (during installation process)
The SpeedTouch™
Installation
The SpeedTouch™ installation consists of two major parts:
• The software installation procedure
• The hardware installation procedure
If you want to connect to the Internet via a PPP (PPPoA or PPPoE) connection some
additional configuration is required.
Mac OS X differences Depending on the Mac OS X version your computer runs, some windows may differ
from the windows shown in the installation procedures.
The driver installation
procedure
Proceed as follows:
1 Insert the SpeedTouch™ Setup CD-ROM in your computer's CD-ROM drive and
open the OSX folder.
2 Open the Setup folder.
3 Depending on your Service Provider’s specifications open either the:
• WAN folder
to install a PPPoA connection or a PPPoE connection
• LAN folder
to install an RFC1483 Bridged connection.
4 In this folder open the folder corresponding to your local setting (this should be
specified by your Service Provider) and double-click SpeedTouchUSB.pkg to start
the installation procedure.
Note If your computer runs Mac OS X v10.1 or v10.2, the installation wizard
may prompt you for authentification. If this is the case, click to
enter your credentials.
Note If your computer runs Mac OS X v10.3, your computer will prompt
you to run a program to determine if the installer package can be
installed. Click Continue.