Filter
Top Products
4
1.3 Installing the H-UDI Port Connector on the User System
Table 1.3 shows the recommended H-UDI port connectors for the emulator.
Table 1.3 Recommended H-UDI Port Connectors
Connector Type Number Manufacturer Specifications
DX10M-36S Screw type
36-pin connector
DX10M-36SE,
DX10G1M-36SE
Hirose Electric Co., Ltd.
Lock-pin type
14-pin connector 2514-6002 Minnesota Mining &
Manufacturing Ltd.
14-pin straight type
38-pin connector 2-5767004-2 Tyco Electronics AMP K.K. 38-pin Mictor type
Note: When designing the 36-pin connector layout on the user board, do not connect any
components under the H-UDI connector. When designing the 14-pin connector layout on
the user board, do not place any components within 3 mm of the H-UDI port connector.
When designing the 38-pin connector layout on the user board, reduce cross-talk noise etc.
by keeping other signal lines out of the region where the H-UDI port connector is situated.
As shown in figure 1.1, an upper limit (5 mm) applies to the heights of components
mounted around the user system connector.