Filter
Top Products
32176 Group
Starter Kit User’s Manual M3A-2152
REJ10B0224-0300/Rev.3.00 Jan. 2007 Page 6 of 82
3. Usage Precautions
3.1 Guaranteed Scope of the Starter Kit
The Starter Kit was developed for users to trial the 32176 Group microcomputer specifications and
development environment. Therefore, the results arising from the use of the Starter Kit are not
guaranteed.
The M3A-2195 (SDI Interface Board with Housing) was developed for use with only the Starter Kit.
If the M3A-2195 is used with any other system, its operation cannot be guaranteed.
When developing/debugging a system product using one of the M32R Family microcomputers,
please be sure to use official development tools separately available as you debug.
The Starter Kit should be run on the designated type of host machine (IBM PC/AT compatibles).
This designated type of host machine, however, is just an anticipated operating environment for the
Starter Kit and does not mean that the Starter Kit operates properly on all relevant types of
machines in all relevant environments (e.g., device drivers and peripheral units).
3.2 Regarding About System Power-on Sequence when Connected to the Emulator
3.2.1 M3A-2152G52A in Use
- When turning on power, turn on M32100T-EZ-E first and then the M3A-2152 Evaluation
Board.
- When turning off power, turn off the M3A-2152 Evaluation Board first and then
M32100T-EZ-E.
- When turning on power again after turning off power, wait for 10 seconds.
- Power to M32100T-EZ-E can be fed from USB cable.
Note: Unless the Starter Kit is powered on this sequence, the kit may operate erratically or break down.
3.2.2 M3A-2152G52 in Use
- When turning on power, turn on M3A-2195 first and then the M3A-2152 Evaluation Board, or
simultaneously.
- When turning off power, turn off the M3A-2152 Evaluation Board first and then M3A-2195, or
simultaneously.
- When turning on power again after turning off power, wait for 2 seconds.
Note: Unless the Starter Kit is powered on this sequence, the kit may operate erratically or break down.