Filter
Top Products
( 3 / 4 )
6. External Dimensions of the M3T-DUMMY100S
Figure 3 External dimensions of the M3T-DUMMY100S
7. Sample Foot Pattern of a Target System
Figure 4 Dimensions of a target foot pattern (Quoted from the specifications of IC socket for QFP by Matsushita Electric Works, Ltd.)
Unit: mm
Board
Pin
Upper connectors
(J1, J2)
Material: Glass epoxy board
Material: Bronze phosphide
Plating: Solder plating
Material: Heat tolerant resin (body)
Copper alloy (post, contact)
Plating: Nickel-based gold plating
Upper connector J1: AXN650545P
(made by Matsushita Electric Works, Ltd.)
Upper connector J2: AXN550045P
(made by Matsushita Electric Works, Ltd.)
: Pin number of the M3T-DUMMY100S
: Pin number of the upper connectors
Note:
Be sure to set up foot patterns for
the holders. Make the thickness
and the area of the solder-print
screen thicker and larger than the
foot patterns recommended so as
to secure a sufficient amount of
solder applied.
(In carrying out manual soldering,
an amount of solder sufficient for
forming a larger fillet than that
formed at the time of reflow is
required.)
As the contacts of the IC
socket body touch the PC
board, thus be sure to give
special consideration to the
patterns of traces so that no
other pins touch the PC
board.
(Through-hole mounting is
not permitted.)
Symbol
A
b
D
E
e
HD
HE
M
Dimension [mm]
5.0
0.4
14.0
20.0
0.65
16.8
22.8
6.3
Foot pattern for holders (x 4)
(These patterns are essential.)
Foot pattern recommended by Matsushita Electric Works, Ltd.
1
1
B