Filter
Top Products
24. Select the “Debug_HMon” build configuration in the left hand
drop down list on the toolbar.
25. Click on the “Build” icon to compile, assemble and link the project.
4. Programming and Debug
Before connecting to the RSK, HEW needs to know which device is being used so that the correct programming
kernel can be used. To set this information the Flash wizard needs to be invoked.
26. Click on the ‘Configure Flash Project’ button
The FDT configuration wizard will be launched.
27. Select the “SH2A/7211” device from the drop down
list.
28. In the kernels displayed it is very important to select
the kernel with .RSK at the end of the name. This is
because this kernel has been modified to support the
debugger.
29. Accept all the default settings by clicking <Next> to
the end of the wizard.
Note: Two warning dialogs will be displayed, accept
the dialogs.
30. Select (File> Save Workspace) from the main
toolbar.
31. The FDT settings have now been saved and it is time
to attempt the initial connection to the board.
32. The HEW workspace contains two debug sessions. The Default session does not include any debugger
information. This can be used to add support for other debugging tools such as the Renesas E10A.
33. Ensure the “Session_SH2A_HMon” session is selected in the right hand drop down list on
the tool bar. The Debug toolbar connection button will become active.
34. Click the <Connect> button on the debug toolbar
35. In the “Select Target Configuration File” dialog choose “SH7211.tcf” <OK>.
36. When asked if it is OK to assume only one E8 will be connected, click
<Yes>.
If your E8 Firmware needs updating, a warning dialog will be displayed.
Click <OK> to continue.
The message pane at the bottom of the workspace window will show details of current progress.
Note: If this is the first time the E8 has been used in E8Direct mode then there will be a short delay and the Found
New Hardware wizard will be invoked for a second time. This is to support the debugging function of the E8Direct
mode. Please refer to the instructions below to install the different driver.
D007394_11_S01_V01