Filter
Top Products
First time E8 Direct Driver install only
The ‘Found New Hardware’ Wizard will appear.
37. Verify the “Recommended” option is selected and click <Next>.
38. If using Windows XP, skip to step 40; otherwise click <Next>.
39. Click <Next> to install the driver.
40. Click <Finish> to close the wizard.
You may be prompted to select the USB device in a new dialog:
41. Click <OK> to select the USB device.
42. In the “E8 Direct Configuration” dialog box set the baud rate to 250000 and
power supply option to “E8 provides 5V”. Click <OK>.
If this is the first time you have connected to the RSK and all connections are
correct then the connection will be completed, so go to step 44.
43. If the connection fails then you will be returned to the configuration screen. Click
<Abort>.
Note: It is possible that a working HMon project is not programmed in to the
device.
Select “Download HMon using Boot Mode” and click <OK>.
A warning dialog will be shown, click <OK> to accept it.
A dialog will be shown with the boot mode pin settings, click <Finish>
HMon will program the device in Boot mode and then swap back to User mode.
A debug connection will then be attempted. If the connection fails the
“Connection Error” dialog will be re-displayed.
Re-check the settings and connections and try again.
44. Right click on the <project_name>.abs file listed in the download modules
area of the Workspace view and select “Download”.
The HMON Configuration dialog will be displayed.
45. Select “Compare with cache”.
D007394_11_S01_V01
46. Click <OK>.
The code will be downloaded to the device.
47. Click the ‘Reset – Go’ button.
The code will run and you will see the LEDs flash on the board.
48. Click the ‘Stop’ button.
The code will stop and the source code opened at the current program
counter.