Filter
Top Products
Eject button
This is the button used to eject or insert in the disc tray.
5.
Emergency eject hole
This drive has a function that allows the disc to be ejected manually if this becomes necessary
in an emergency such as failure of the drive or a power outage.
Caution
This feature is a last measure to be used only in an emergency. Using it
excessively will cause malfunction.
6.
Rear panel
Digital Audio Output Connector
Provides output to a sound card (Digital signal).
1.
Analog Audio Output Connector
Provides output to a sound card (Analog signal).
2.
Jumper Connector
This jumper determines whether the drive is configured as a master or slave. Changing the
master-slave configuration takes effect after power-on reset.
3.
IDE Interface Connector
Connect to the IDE (Integrated Device Electronics) interface using a 40-pin flat IDE cable.
Caution
Do not connect or disconnect the cable when the power is on, as this could
cause a short circuit and damage the system. Always turn the power OFF when
connecting or disconnecting the cable.
4.