Filter
Top Products
OPERATION
Preparation For Printing
4. Place the paper on the paper feed
table.
~
Make sure every sheet in the stack is set
evenly. This helpsprevent paperskewing.
CJ Make sure the leading edge of the staok
is infull contact with the front board.
0 500 sheets of paper can be loaded at a
time. If you load more than 500 sheets,
paper may not be fed properly.
~ Do not stack paper over the paper feed
side plates.
5. Lift the feed roller pressure lever.
Caution: Be careful not to catch your finger
between the /ever and the side
paneL
6. Make sure that the paper feed side
plates contact the paper gently.
O The paper feed side plates should be
parallel to the sides of the paper stack,
othenvise the paper might not be fed
correctly.
Printing on thick and small paper
r I
Set the side pads before adjusting the
paper feed side plates to match the
paper size.
Thick and small paper:
Heavier than 150 g/mz, 39.9 lb
Smaller than 210 x 150 mm,
8.3”
X 5.9”
l-m- 11 LI
-
J
,L3 II
III
16
.. ..