Filter
Top Products
14
User Manual
SATA 4 Port PCI Adaptor with RAID RC209
BIOS will show up and indicate the devices attached to it.
Driver Installation
Quick guide:
1. If you want to add RC-209 to an existing OS, set up RC-209 into a PCI slot. Enter the OS
and install RC-209 with driver disk. In this case, PC is booting up by an existing HD
connecting to motherboard. After RC-209 is installed complete, you can add HD and set the
RAID by RAID BIOS.
2. If you want to add RC-209 to a new PC without any OS, you need to boot the OS from HD
connecting to RC-209 instead of motherboard.
a. Put the driver (the driver must fit the OS you want to install to the HD) into a floppy disk
and keep it in the floppy drive.
b. Plug the HD. Turn on PC and press F4 to complete the RAID set. After you complete,
save and left the setting.
c. Inset Windows installation disk and start the windows installation.
d. Press F6 at the beginning as the blue screen scanning.
This will let PC boot from a HD controller instead of motherboard HD.
e. Keep the floppy in floppy drive and follow the installation. Press “S” when the screen
shows as the following picture.