Filter
Top Products
5
User Manual
SATA 4 Port PCI Adaptor with RAID RC209
Mode 4 - ABCE Active
Note: There are six SATA ports in Serial ATA 4-Channel RAID adapter. We named these ports
character A through F. Ports A to D are internal SATA ports and E & F are external SATA ports. By
changing the jumper setting on the Serial ATA 4-Channel RAID adapter that allows you to utilize 4
ports of this card at the same time. Please set which port to work by jumper setting. By default,
Port A, B, C and D are working.
Hardware Installation
1. Turn Off the power to your computer and any other connected peripheral devices.
2. Unplug the power cord form the back of the computer.
3. Remove your computer’s cover.
4. Remove the slot bracket from an available PCI slot.
5. To install the card, carefully align the card’s bus connector with the selected PCI slot on
the motherboard. Push the board down firmly, but gently, until it is well seated.
6. Replace the slot bracket’s holding screw to secure the card.
Device Connection
The Serial ATA 4-Channel RAID adapter is a four channel Serial ATA controller that supports up
to four Serial ATA hard disk drives. It is recommended to use identical hard drives for all RAID
configurations.
1. Install your hard disk drive(s) in chassis.
2. Connect the Serial ATA hard disk drive to the system power supply using the included Serial
ATA power cable.
CD
E
F
Active
1.2 close
2.3 close
AB
Active