Filter
Top Products
20
User Manual
e-SATA 4 Port PCI Adaptor with RAID RC-209-EX
4. At the Windows Setup screen, press Load Driver to install the RAID driver.
5. Insert the floppy disk, please select Silicon Image SiI 3114 Soft Raid 5 Controller
(A:\si3114r5.inf), then press Next. (Change A:\ to match your floppy drive letter)
6. Follow the on-screen instructions to complete the Windows installation.
For An Existing Installation
1. Setup the RAID Array prior to driver installation and boot up to Windows.
2. At Found New Hardware Wizard, select Locate and install driver software (recommended).
3. Please insert driver CD, click Next.
4. If the system prompts the user informing the drivers are not signed, select the option Install
this driver software anyway.
5. Click Close to complete the installation.
For Windows® Vista-x64
For New Installation
A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy
the contents of the “RC-209\64-bit Windows\RAID5” folder, found on the driver CD, onto a
blank floppy disk then follow the directions below.
1. Setup the RAID Array prior to Windows installation.
2. Follow Microsoft’s Windows installation procedure.
3. Restart the computer when prompted by Windows’ installation.
4. At the Windows Setup screen, press Load Driver to install the RAID driver.
5. Insert the floppy disk, please select Silicon Image SiI 3114 Soft Raid 5 Controller
(A:\si3114r5.inf), then press Next. (Change A:\ to match your floppy drive letter)
6. Follow the on-screen instructions to complete the Windows installation.
For An Existing Installation
1. Setup the RAID Array prior to driver installation and boot up to Windows.
2. At Found New Hardware Wizard, select Locate and install driver software (recommended).
3. Please insert the driver CD, click Next.
4. If the system prompts the user informing the drivers are not signed, select the option Install
this driver software anyway.
5. Click Close to complete the installation.