4. After pressing the button choose and set proper speed by using
the and button.
5. It is when ready is show on the screen and the buzzer rings three times.
sound three times.
6. Turn on the take up device and set the proper film tension by pressing the
button. Lower tension would make better operation.
7. Set document on the table.
You should allow at least 5mm(1/4”)
space on each side for perfect laminations
8. Turn the switch “Run” and
“take up motor” at the same time.
The liner and film will be rolled at
the same time.
9. When lamination is finished, press the
button. For your convenience,
it would be better to set table guide in
proper position. And if needed,
cut documents with cross cutter.
10. Set pressure lever at the Hard board/15mm mode.
11. Turn off the power switch.
1. Set up the protection paper. Otherwise, glue form the film will be stuck on the face
of roller and it can be seriously damaged.
2. Turn the switch “Run” and “Take up motor” at the same time.
3. For worm lamination, set temperature from the hot mode.
1. It is convenient to use the remote control in the back of machine while laminating.
2. It is also convenient if you use Foot Switch while laminating HARD BOARD.
3. "RUN", "STOP", "REV" buttons on Remote Control have same functions
with the ones on Control Panel.
TIPS FOR REMOTE CONTROL AND FOOT SWITCH
*** Reference ***
C/HOT
RUN
STOP
SPEED
- 22 -