Filter
Top Products
Operation
Runco VX-2000d Owner’s Operating Manual 59
PRE
L
IMINAR
Y
HD/RGB Adj. Select HD/RGB Adj. from the Main Menu to view input signal resolution and timing
information. To do this, select Signal Info from the HD/RGB Adj. menu.
Signal Info: Select Signal Info from the HD/RGB Adj. menu to display the resolution,
horizontal frequency and vertical frequency of the input current signal.
OptionsSelect Options from the Main Menu to perform the following projector configuration tasks.
Image Shift: Select Image Shift from the Options menu to vertically shift the projected
image.
Subtitle: Select Subtitle from the Options menu to adjust the projected image height in
small increments.
Overscan: Refer to Overscan on page 46.
Default: To reset the Overscan setting to its default value, select Default from the Options
menu, then select Yes to confirm the reset.
LED: Select LED from the Options menu to change the behavior of the projector’s
indicator LEDs.
• When set to ON, the LEDs indicate operating status as described in VX-2000d at a
Glance on page 5.
• When set to OFF, the LEDs illuminate when the VX-2000d is in standby mode, warming
up or indicating an error condition; otherwise, they are off.
Lamp Hours (read-only): Refer to Lamp Hours on page 50.
OSD: When you select an aspect ratio or input with the remote control (or from the DHD
Controller), the VX-2000d displays your selection on-screen. To prevent the display of
these items, select
OSD from the Options menu and set it to Off.
Signal Type: Select Signal Type from the Options menu to specify the incoming signal
type (encoding method):
• Choose Auto to have the VX-2000d automatically detect the signal type.
• Choose RGB (1) for RGB-encoded video signals.
HD/RGB Adj.
Frequency 0
Phase 0
H-Shift 0
V-Shift 0
Default
Special Modes
Signal info
Auto Setup
Ima
g
e Shift 0
Subtitle 0
Overscan 30
Default
Adjust Black Level 0
LED
On
Options
OSD On
Signal Type 3
Lamp Hours
HDMI Black Level 0
Color Space
Auto
Background
Power Save
Baud Rate 9600 bps
Fan Mode 2
Orientation
FF
Factory Default
Adjust White Level 0
Overscan +
-
5%
Image Shift and Subtitle can only be adjusted for certain 1080i
signals.
When you set the Auto Power Off function (refer to Power Save,
below) to Off, the LED function is automatically set to On.
Note
Note