Filter
Top Products
Installation
Runco VX-6000d Installation/Operation Manual 43
PRE
L
IMINAR
Y
3.8
Primary Lens
Adjustments
Lens zoom and focus are motorized adjustments that are adjustable using the Setup
remote control (
Figure 2-6). This allows you to adjust the focus and image size while at the
screen for more accurate results. The remote control has a range of approximately
100
feet (30.5 meters) for long throw distances.
The IR receiver for the lens motor assembly is
located on the projector behind the front Runco
logo cover. Rotate the logo cover 90 degrees as
shown to reveal the IR receiver opening.
Focus1. With the IR receiver revealed on the front of the projector, press the VX6K button on
the Setup remote control to display the Lens Control menu page.
2. Point the remote directly at the projector for maximum range.
3. To focus the projected image, press and hold the FCUS+ or FCUS- button.
ZoomTo make the picture smaller (zoom out), press and hold the ZOOM- button. To enlarge
the picture (zoom in), press and hold the ZOOM+ button.
IrisPress the IRIS button repeatedly to select an optical aperture or iris size (large or small).
Vertical and Horizontal
Lens Shift
To change the projected image position, use a 3/16” hex driver to shift the lens in the
desired direction; see
Figure 3-20. The vertical lens shift control is at the top of the
projector; the horizontal lens shift control is on the same side of the projector as the lamp
compartment cover. (The tool will automatically center on top of the adjustment nut when
inserted into the access hole.)