Filter
Top Products
Getting started_29
3. Click
Wireless
and Select
Wizard
. Then, click
Next
.
4. Select the one
Network Name(SSID)
in the list
.
•
SSID
: SSID(Service Set Identifier) is a name that identifies a wireless
network. Access points and wireless devices attempting to connect
to a specific wireless network must use the same SSID. The SSID is
case-sensitive.
•
Operation Mode
:
Operation Mode
refers to the type of wireless
connections.
-
Ad-hoc
: allows wireless devices to communicate directly with each
other in a peer-to-peer environment.
-
Infrastructure
: allows wireless devices to communicate with each
other through an access point.
5. Click
Next
.
If wireless security setting window appears, enter the registered
password (network key) and click
Next
.
6.
Wizard Setup Confirmation
window appears, please check your
wireless setup. If the setup is right, click
Apply
.
7. Click
OK
.
Now go to Installing the driver software.
Installing the driver software
You must install the printer driver software for printing. The software
includes drivers, applications, and other user friendly programs.
If your IP assignment method is DHCP and IP address can be changed
whenever machine is turned on, we recommend you to use the Bonjour
program. Go to the http://developer.apple.com/networking/bonjour/
download/, select the program Bonjour for Windows according to your
computer operating system, and install the program. In case of Mac OS X,
this program might be already installed in your PC. This program will allow
you to fix the network parameter automatically. This Bonjour program does
not support Linux.
If your IP assignment method is static, follow the steps below.
1. Insert the Printer Software CD-ROM into your CD-ROM drive. The CD-
ROM should automatically run, and an installation window appears.
2. Click Next.
Wizard
will help you setup the wireless network configuration.
However, if you want to set the wireless network directly, select
Custom
.
If your network’s operation mode is
Infrastructure
, select the
SSID
of the access point. If the operation mode is
Ad-hoc
, select the
machine’s
SSID
. Note that “airportthru” is the default
SSID
of your
machine.
Disconnect the network cable (standard or crossover). Your
machine should then start communicating wirelessly with the
network. In case of
Ad-hoc
mode, you can use a wireless LAN
and wired LAN simultaneously.
If
Operation Mode
is
Infrastructure
, you must disconnect the
network cable to activate wireless network after completing the
network setting.
• The following procedure is based on Windows XP. The procedure
and popup window which appears during the installation may differ
depending on the operating system, machine features, or the
interface in use.
• Make sure that the network setup for your machine is completed.
(See "Setting up the network" on page 21.) All applications should
be closed on your computer before beginning installation.