Filter
Top Products
Samsung Electronics
Service Manual
Disassembly and Reassembly
5-8
5.2.8 RX Drive
1. Before Disassembling
-Separate the font cover.(Refer to 5.2)
-Separate the SMPS cover.(Refer to 5.3)
-Separate the Main cover.(Refer to 5.4)
2. Release 2 screws (Screw x 2:Silver_M3, 6001-
000130) connected to the engine shield and 6 screws
(Screw x 6: Gold_M3,6003-000296)connected to the
frame. Separate the RX drive by pulling it out toward
the arrow direction.
3. Remove the connector from the separated RX drive.
4. After removing the RX drive,RDCN Gear, OPC Gear,
Fuser Gear, and Feed Gear can be removed from the
frame.
5. When separating the motor,remove the motor bracket
first by removing 4 screws as shown as below, and
then remove the 2 screws from the motor bracket.
RDCN Gear
OPC Gear
Fuser Gear
Feed Gear
Please, be careful not to touch the protruding 4 screws at the out-
side of the RX drive.
Note:
RX Drive
RX Motor
Motor Bracket
Gear Bracket