Filter
Top Products
6_SADT-104WM
10. Connect the cables of the Camera Adaptor with the outward cables, which then you
push in through the Cover Fixing Part to the Wall Mount Adaptor.
Insert one piece of the two-strand cable into an empty area of the Wall Mount
Adaptor as in the figure below and push the other one into the Wall Mount Adaptor.
CAUTION
When you insert the cables into the Cover Fixing Part so that the insulation of the
cable junction is not peeled off or torn.
11.
As in the bottom-left figure, insert the rib of the cover into the Cover Fixing Part. Then,
push the Sanp-Fit of the cover into the Cover Fixing Part so that the cover is fastened
with the Wall Mount Adaptor.
WALL MOUNT ADAPTOR WALL MOUNT ADAPTOR
< Insert one piece of the two-stranded cable > < Insert the other piece of the two-stranded cable >
the place for joining a cover
WALL MOUNT ADAPTOR
WALL MOUNT ADAPTOR
the place for joining a cover
CAMERA ADAPTOR
CAMERA ADAPTOR
COVER
COVER
COVER
RIB
SNAP-FIT
SADT-104WM_ENG.indd 6 2008-01-24 오전 10:24:08