Filter
Top Products
SAM52 User's Manual Menu Functions
11
2. Complete the Create New Store dialog according to the Store Information table below:
Store Information
Field Name
Required
/Optional
Description/Instructions
Name
R
Enter an eight-character store name.
Store#
O
Enter a four digit number store number.
Phone#
O
Enter the Phone number preceded by the letter
T
or
P
if
you intend to communicate with the register by modem.
The
T
is for TONE and the
P
is for PULSE. If you
communicate direct, leave this field blank.
COM Port#
R
Select the PC serial port (COM1- COM4) that you are
using for communications.
Down Load
PLUs after
Polling
O Enter Y if you wish to download PLUs in a polling
session. When the session is finished polling, the program
will download the PLU file.
Deactivate
This Store
O
Select the Deactivate This Store check box if you wish the
store to be inactive.
Modem Time
Out Value
R
Unless otherwise indicated, the default value of 99 will be
entered automatically when the store is created
Modem Initial
String
O
This field is to allow you to enter any initialization
required for your modem for polling or communications.
Do not add the command prefix “AT” in this string. If you
are using the U.S. Robotics Sportster modem, it would be
good to initialize with the string S7=60. This value makes
the modem wait for up to 60 seconds to detect a carrier. If
no carrier is detected within 60 seconds after you dial, the
modem will answer back with No Carrier Detect. Do not
put into this string any E, Q or V values. The software
automatically handles these values.
Baud Rate
R
Select 9600, 4800, 2400, 1200, or 19,200. Be sure that the
rate set on the register (Port Settings) matches the store
information rate set here.
3. Click Exit to save store information.