Filter
Top Products
Rev. 2.01
- 11 -
SRP-370/372 Ver.2
1-4 Setting the Dip Switches
1-4-1 Serial Interface
Switch No. Function ON OFF Default
SW1-1 ON
SW1-2
Baud Rate Selection * Refer to below Table
ON
SW1-3 Handshaking
Software
(Xon/Xoff)
Hardware
(DTR/DSR)
OFF
SW1-4 Reserved -- OFF
SW1-5 Cutter Function Disable Enable OFF
SW1-6 Paper 2 Color Mono OFF
SW1-7 Reserved -- OFF
SW1-8 Reserved -- ON
DIP switch Setting 1 Function
SW1-1 SW1-2 Trans- Speed Remark
OFF OFF 9600 Baud
ON OFF 19200 Baud
OFF ON 38400 Baud
ON ON 115200 Baud Default
Baud Rate Selection
Switch No. Function ON OFF Default
SW2-1 OFF
SW2-2 OFF
SW2-3
Select Print Density * Refer to below Table
OFF
SW2-4 Historical Control Enable Disable OFF
SW2-5 Reserved -- OFF
SW2-6
Interface Condition
Selection
by Memory
Switch
by DIP
Switch
OFF
SW2-7 Near End Sensor Status Disable Enable OFF
SW2-8 Printing width 2” Printing 3” Printing OFF
DIP switch Setting 2 Function
SW 2-1 SW 2-2 SW 2-3 Print Density Remark
ON ON ON 130%
OFF ON ON 120%
ON OFF ON 110%
OFF OFF ON 105%
OFF OFF OFF 100% Default
ON OFF OFF 95%
OFF ON OFF 90%
ON ON OFF 80%
Select Print Density