Filter
Top Products
English 19
English
FrançaisDeutschEspañolPortuguese Italiano
* According to our R&D Lab test result, "Channel auto program" usually takes around 3
minutes to scan 61 channels. The scanning can be longer or shorter depending on the number
of channels and the video source whether the video source is from cable or air.
*Upon completion of "Channel auto program", the result of the channel search is stored in
designated internal memory. Each found channel is indexed into that memory and the channel
indices are used as a look up table. In other words, when a user changes the channel, the
monitor refers to the look up table to find the appropriate channel freqency instead of
performing physical frequency scanning which gives a lot slower tuning result. In rare cases,
"Channel auto program" may miss a channel due to weak signals or for other reasons. To add
a channel, please enter the channel number by using the numeric key pads on the remote
controller, then use "Fine Tune" menu in the "TV Setup" menu from OSD. When you finish fine
tunning the channel you want to add, select "Save".
Adjusting Your LCD Monitor
body2.fm Page 19 Tuesday, August 29, 2000 2:21 PM