Filter
Top Products
10
Chapter 2. Connecting the Cable
2-1. Connecting the AC adapter to your printer
When the printer is used, use the optional AC adapter, NH36-240150-I1 for your
printer.
WARNING
Using an incorrect power supply may cause fire or electrical.
CAUTION
When connecting or disconnecting the power supply from the printer, make sure
that the power supply is not plugged into an electrical outlet ; otherwise you may
damage the power supply or the printer
1. Make sure that the printer's power switch is turned off, and that the power
supply's power cord is unplugged from the electrical outlet.
2. Check the label on the power supply to make sure that the required voltage
matches that of your electrical outlet.
3. Plug the power supply's DC cable connector into the printer's power connector as
shown below.
STP-103S / STP-103P
4. Plug the AC adapter's power cord into an electrical outlet.
NOTE
To remove the DC cable connector grasp the connector at the arrow and pull it
straight out. Make sure that the main unit's power cord is unplugged before you
disconnect the DC cable connector.
11
2-2. Connecting the printer to your Computer
STP-103S
You need an appropriate serial interface cable to connect your computer to the
printer's built-in interface.
1. Make sure that both the printer and computer are turned off :
then plug the cable connector securely into the printer's interface connector.
2. Tighten the screws on both sides of the cable connector.
3. Plug the other end of the cable into the computer.
25 Pin Female Type