Filter
Top Products
19
Connecting to PAN/ TILT /ZOOM/ FOCUS Controller
The RX/TX terminal of the reverse side of the SNS-110 uses the RS-442/485 interface and
PAN/TILT/ZOOM/FOCUS controllers can be connected to the terminal.
The PAN/TILT/ZOOM/FOCUS controllers that are supported are the following.
● Samsung Smart-Dome Camera (SCC-641) ● Pelco : Pelco-P Protocol Support Control
● Sungjin Electronic Communications : CPU-Receiver
The TX+ and TX- of the terminal as shown in picture, is connected to the external terminal of the
PAN/TILT/ZOOM/FOCUS controller, and generally the external terminal has a +,- polarity indication so be
sure not to switch the polarity.
Set the F/H Switch to On (knob faced down) on the front side of the SNS-110.
Refer to the PAN/TILT/ZOOM/FOCUS controller manual and confirm & reset the following items.
● Baud Rate ● Data Bit
● Stop Bit ● Parity Bit
● Controller ID (be careful not to duplicate a different controller ID)
ALARM IN
R/O
RX
TX
1 2 3 4 - + - +
RA
RC
GG
P/T/Z/F Controller 1
P/T/Z/F Controller 2
P/T/Z/F Controller 3
P/T/Z/F Controller 4
When connecting Samsung Smart-Dome Camera (SCC-641), you have to connect the
SNS-110 to the TxDt, - terminals of SCC-641. In this case, the supportable Baud Rate
is 38400 and 19200bps. For more detail information, please refer to the user manual
of SCC-641.
Reference inquire the shop at which it was purchased for the products other
that the above PAN/TILT/ZOOM/FOCUS camera and controllers.
Note
RX-
RX+
RX-
RX+
RX-
RX+
RX-
RX+
If several PAN/TILT/ZOOM/FOCUS controllers are used, they must be the same
models.
Caution