Filter
Top Products
48
③
Pswd Enable
Restricts the access from other users. If you check the check box of
"
Pswd Enable
"
and click
"
Apply
"
button, you should input registered username and its password in Log-in window to
access to the Application mode.
If you don’t check the check box of
"
Pswd Enable
"
, anyone is accessible to the Application mode.
(4) S/W Upgrade
Upgrade the currently installed program in SNS-110 to the most updated version.
①
Download the updated program version from Samsung Electronics web site .
(www.samsungelectronics.com), or from SNS-110 service man. The file name of SNS-110
program is sns110_vXXX_XXXX.bin.
②
Save the updated program version in the directory of SNS-110-connected PC.
③
Click
"
Browse
"
and select the updated program, sns110_vXXX_XXXX.bin, in the directory.
The selected file will be saved in the browse window.
④
Click
"
Install
"
and open dialog window. You will see caution message, then click
"
OK
"
to start
program upgrade. Upon the upgrade completion, you will see another dialog window. You must
wait approximately for 2 minutes.
⑤
Reboot SNS-110 after the upgrade being completed as shown below.
● Press
"
Reset
"
button on the front panel.
● Turn off and then on SNS-110.
⑥
After successfully upgrade the program, execute web browser and Log-in.
Anyone, who is accessible to Administration mode, may change configuration
of SNS-110. If the configuration is deleted or altered, the system may be
damaged or malfunction. Therefore, factory default is set up with root
password.
After the initial installation, you are strongly recommended to change the root
password and restrict the access from other users.
Caution
Wait until the "Upgrading is successful! New code will be loaded after
reset" message appears. Rebooting SNS-110 before this message can
cause fatal damage to the machine.
Caution