Filter
Top Products
65
APPENDIX B Factory Default
Items Factory Default Value
Camera 1~4 Camera Input Blank
Size Normal
Video Quality Low
Text Display Blank/No
PAN/TILT/ZOOM Disable
Apply to Only Cemera 1~4
P/T/Z Device None
Baud Rate 2400
Data Bit 8
Stop Bit 1
Parity Bit None
Camera 1 ldentity 0
Camera 2 ldentity 1
Camera 3 ldentity 2
Camera 4 ldentity 3
Quad/ Quad Size Normal
Sequential Sequential Size Normal
Sequential Interal 3
System NTSC
Web Date & Time 2001/January/1 00:00:00
Transmitter Security Administration ID:root/Password:w2000
User ID: guest 1/Password:guest1
Password Enable
Software Upgrade Blank
Factory Default sets the program back to the condition at the time of purchase.
Please note that after Factory Default has been enabled, network information is also deleted, so establishing
a connection is impossible. Refer to Chapter 4, Setting an IP Address, in order to set a new IP address.
How to Enter the Factory Default
(1) Power on the SNS-110 or push the ‘Reset’ button in front of the SNS-110 while pushing the ‘PRESET’
button. Then the Power LED of SNS-110 turns on and off just one time. The turn state of Power LED
says that the progress of Factory Default is going on. Hole on pushing the ‘Reset’ button.
(2) When the progress of Factory Default cornplete, the Power LED turns on again.
Stop pushing ‘Reset’ button.
(3) All the setting of SNS-110 returns as the state of purchase.
Values for setting up SNS-110