Filter
Top Products
15
English
Powering On the Projector
1. Ensure that the power cable and signal cable are securely
connected. The POWER LED will turn red.
2. Remove the lens cap.
3. Turn on the lamp by pressing “ON/STAND-BY” on the
control panel or the remote control. The POWER LED will
ash blue.
The startup screen will display in approximately 5 seconds.
When disappear startup screen, the POWER LED will turn
blue.
4. Turn on your source (computer, notebook, video player,
etc.) The projector will detect your source automatically.
If you connect multiple sources at the same time, use the
“INPUT” on the remote control or use “COMPUTER”, “S-
VIDEO”, “VIDEO” on the remote control to switch inputs.
Powering On/Off the Projector
Turn on the projector
rst and then the signal
sources.
N
o
t
e
Lens Cap
ON/STAND-BY
1
2
OR