Sanyo PLC-XU25/A Projector User Manual


 
17
Installation
Connecting to a Computer
ONON
COMPUTER IN 1
DVI - I
MONITOR OUT
S-VIDEO
COMPUTER IN 2 /
COMPONENT IN /
COMPUTER /
COMPONENT
AUDIO IN
AUDIO IN
R VIDEOL
USB
SERVICE PORT
RESET
MCI
(MONO)
(VARIABLE)
AUDIO OUT
ON
1
DIP
ON
OFF
23456
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
OFF
ON
ON
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
3456
OFF OFFON ON21" MODE (1152 x 870)
ON ON
ON
ON
OFF
OFF
12
ON ON
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
DVI-VGA Cable
Monitor Output
Desktop type Laptop type
Audio Speaker
(stereo)
Audio Amplifier
Audio Cable
(stereo)
Audio Output
Audio Input
AUDIO OUT
COMPUTER/COMPONENT
AUDIO IN
Cables used for connection (= These accessories are not supplied with this projector.)
Audio
Cable
(stereo)
NOTE :
When connecting the cable, the power
cords of both the projector and the
external equipment should be
disconnected from AC outlet.
USB port
MAC Adapter
Set slide switch-
es according to
the chart below.
• VGA Cable (HDB 15 pin)
• DVI-VGA Cable (HDB 15 pin)
• DVI-Digital Cable (for Single Link T.M.D.S.)
• USB Cable
• MAC Adapter (When connecting to Macintosh computer)
• Audio Cables ( Mini Plug (stereo) x 2)
External Audio Equipment
Terminals
of the Projector
VGA
Cable
Monitor Output
or
Monitor Input
USB
COMPUTER IN 2 /
COMPONENT IN/
MONITOR OUT
Set switches as shown in the table
below depending on RESOLUTION
MODE that you want to use before
you turn on projector and computer.
MAC ADAPTER (Not supplied)
USB
Cable
COMPUTER IN 1 DVI-I
DVI Cable
Monitor Output
COMPUTER IN 1 DVI-I
NOTE
This terminal is switchable. Set the terminal
up as either Computer input or Monitor
output before using this terminal. (See Page
39.)