Filter
Top Products
Setting
43
Capture
This function enables you to capture the image
being projected and use it for a start-up display or
interval of presentations.
After capturing the projected image, go to the
Logo select function and set it to "User". Then
the captured image is displayed when turning on
the projector next time or pressing the NO SHOW
button. (p.24)
To capture the image, select [Yes]. To cancel the
Capture function, select [No].
✔ Note:
• Before capturing an image, select Standard
in the Image Select Menu to capture a proper
image. (p.30, 37.)
• A signal from a computer can be captured
up to XGA (1024x768). A signal from video
equipment can be captured except for 720p,
1035i, and 1080i.
• When capturing the image that has been
adjusted by the Keystone function, the
adjustment data is automatically reset and the
projector captures an image without keystone
adjustment.
• When the Logo PIN code lock function is "On",
Capture menu cannot be selected.
• When starting to capture a new image, the
previously stored image is cleared even if you
cancel the capturing.
Select [Yes] to capture the
projected image.
Select [Yes] to stop
capturing.
Capture
This function prevents an unauthorized person from
changing the screen logo.
Off . . . . . . the screen logo can be changed
freely from the Logo select menu.
(p.42)
On . . . . . . the screen logo cannot be changed
without the Logo PIN code.
If you want to change the Logo PIN code lock
setting, enter a Logo PIN code along the following
steps. The initial Logo PIN code is set "4321" at the
factory.
Logo PIN code lock
Logo PIN code lock
Setting