Sanyo PLC-XT10 Projector User Manual


 
12
CONNECTING PROJECTOR
ON
1
DIP
ON
OFF
2345 6
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
OFFON ON
ON ON
ON ON
OFF OFF OFF
OFFOFF OFF OFF
OFF OFF OFF OFF
123456
OFF OFFON ONON ON21" MODE (1152 x 870)
S VIDEO
USB
COMPUTER IN 2
DVI - I
MCI / WI
R AUDIO IN L
(MONO)
VIDEO
Pb / Cb Pr / Cr
Y
MONITOR OUT
COMPUTER IN 1
AUDIO IN 1
AUDIO IN 2
AUDIO OUT
RESET
CONTROL PORT
CONNECTING TO COMPUTER
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
VGA Cable
Monitor Output
Desktop type Laptop type
Audio Speaker
(stereo)
Audio Amplifier
Control Cable
for Serial Port
Audio Cable
(stereo)
Terminal
Serial port
PS/2 port
Audio Output
Audio Input
CONTROL PORT
AUDIO OUT
COMPUTER
AUDIO IN
COMPUTER IN 2 DVI-I
Use one of these Control
Cables corresponding with
the terminal of your
computer.
ADB port
Cables used for connection (= Cable or adapter is not supplied with this projector.)
Control Cable
for PS/2 Port
Control Cable
for ADB Port
Audio
Cable
(stereo)
NOTE :
When connecting the cable, the power
cords of both the projector and the external
equipment should be disconnected from
AC outlet. Turn the projector and
peripheral equipment on before the
computer is switched on.
USB port
MAC Adapter
Set slide switches
according to the
chart below.
VGA Cable (HDB 15 pin)
Control Cable for SERIAL Port
DVI-Digital Cable (for Single Link T.M.D.S.)
Control Cable for PS2 Port , or ADB Port
USB Cable
MAC Adapter (When connecting to Macintosh computer)
DVI/VGA Adapter
Audio Cables {Mini Plug (stereo) x 2}
External Audio Equipment
Terminals
of the Projector
Terminal Terminal
VGA
Cable
Monitor Input
USB
MONITOR OUT
Set switches as shown in the table
below depending on RESOLU-
TION MODE that you want to use
before you turn on projector and
computer.
MAC ADAPTER (Not supplied)
USB
Cable
COMPUTER IN 2 DVI-I
DVI Cable
DVI/VGA
Adapter
COMPUTER IN 1