Sanyo PLC-XW65K Projector User Manual


 
14
To the AC outlet.
(200 - 240 V AC)
Installation
This projector uses nominal input voltages of 100-120
V or 200-240 V AC. This projector automatically selects
the correct input voltage. It is designed to work with
single-phase power systems having a grounded neutral
conductor. To reduce the risk of electrical shock, do not
plug into any other type of power system.
Consult your authorized dealer or service station if you
are not sure of the type of power being supplied.
Connect the projector with all peripheral equipment
before turning the projector on. (See pages 15-17 for
connection.)
Connecting the AC Power Cord
Connect the AC power cord (supplied) to the
projector.
NOTE ON THE POWER CORD
AC power cord must meet requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.
To power cord
connector on your
projector.
Projector side
AC outlet side
Ground
To the AC outlet.
(120 V AC)
For the U.S.A. and Canada
To the AC outlet.
(200 - 240 V AC)
CAUTION
The AC outlet must be near this equipment and must be easily
accessible.
For the U.K.For Continental Europe
Using the ferrite core
0.39" (10 mm)
Ferrite Core
Keep closing until
it makes a clicking
sound.
AC Power Cord
Before using the AC Power Cord, attach the ferrite core
(supplied) as shown in the figure. The Power Cord with
ferrite core must be used for RF interference suppression.
Note:
Unplug the AC power cord when the projector is not in use.
When this projector is connected to an outlet with the AC
power cord, it is in Stand-by mode and consumes a little
electric power.