Filter
Top Products
38
Video Input
COMPUTER button
✳ See Notes at the bottom of this page.
Remote Control
COMPUTER button
Computer 2
✳
S-video
Choose S-video, Component or RGB(Scart) by pressing
the COMPUTER button on the remote control.
Before using COMPUTER button, correct input source
should be selected through Menu operation as described
below.
Input Source Selection (S-video, Component, RGB Scart 21-pin)
Direct Operation
Press the Point ed buttons to move the red arrow
pointer to Computer 1 and then press the SELECT
button.
After the Source Select Menu appeared for Computer
1, move the pointer to S-video, Component or RGB
(Scart) and then press the SELECT button.
1
2
3
Menu Operation
Press the MENU button to display the On-Screen
Menu. Press the Point 7 8 buttons to move the red
framed pointer to the Input Menu icon.
Input Menu
Move the pointer (red
arrow) to Computer 1 and
press the SELECT button.
Input Menu icon
Move the pointer to
S-video, Component or
RGB (Scart) and press the
SELECT button.
Source Select Menu
Computer
1
✔ Notes:
• When the COMPUTER button is
pressed while the Input search function
is set to "On1" or "On2", the input
signal will be searched automatically
(p.46)
• When Monitor out is selected in the
Terminal function (p.50), Computer 2 is
not displayed.
When the input source is coming
from video equipment connected
to the COMPUTER IN 1/S-VIDEO
IN/COMPONENT IN terminal with
a Component-VGA Cable, select
Component.
When the input source is coming
from video equipment connected to
the COMPUTER IN 1/S-VIDEO IN/
COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
Component
RGB (Scart)
When S-video input signal is connected
to the COMPUTER IN 1/S-VIDEO IN/
COMPONENT IN jack with a S-VIDEO-
VGA cable, select S-video.
S-video
✔ Note:
The operations in the figure are processed when the
Input Search function is set to "Off".
Computer 2
✳
Component
Computer 2
✳
RGB(Scart)