Sanyo PCL-WXU10N Projector User Manual


 
EN-18
Powering On/Off the Projector
Powering on the projector:
1. Remove the projector lens cap.
2. Complete the AC power cord and peripheral signal cable(s) connections.
3. Press ON / STAND-BY button to turn on the projector.
4. Turn on your source (computer, notebook, DVD, etc.). The projector automatically
detects your source.
J When searching message appears on the screen, ensure that the appropriate
signal cable(s) are securely connected.
J The signal message will appear on the screen when the source is detected.
J If you are connecting multiple sources to the projector simultaneously, press
INPUT button.
J Remove the lens cap first before powering on.
J Never look into the lens when the lamp is on. This can damage your eyes. It is
especially important that children are not allowed to look into the lens.
J To avoid image sticking, it is not recommended that you project the same still
image for more than 15 minutes.
J Faster on-off-cycles will damage the lamp and reduce lamp life. Wait at least for 7
minutes to turn off the projector after powering on.
Powering Off the Projector:
1. Press ON / STAND-BY button to turn off the projector lamp. You will see a message
“Power Off? Press Power again” appear on the screen.
2. Press ON / STAND-BY button again to confirm.
3. The cooling fans continue to operate for cooling cycle and the Lamp LED goes out.
When the Power LED begins flashing, the projector has entered standby mode.
If you wish to turn the projector back on, you must wait until the projector has completed
the cooling cycle and has entered standby mode.
Once in standby mode, simply press ON / STAND-BY button to restart the projector.
4. Disconnect the power cord from the electrical outlet and the projector.
Please wait until the fan motor and the Lamp LED turn off before removing the AC
power cord from the projector.
Faster on-off-cycles will damage the lamp and reduce lamp life. Wait at least for
7 minutes to turn off the projector after powering on.